SETH'S E-PORTFOLIO
Home
About
RCHS
Orientation to Technology
Stem 1
Production 1
Production 2
3D Printing
CADD/CAM
CADD/CAM 2
CADD
Contact
Stem 1- Acoustic Guitar
Marking where I will drill press the holes.
Drill pressing the holes
gluing the white dots into the holes
sanding the neck of the guitar.
Drilling holes in the neck for the fret board.
routing the neck
Drilling hole for the trust rod
putting glue on the fret board.
angle cutting the tuner head veneer
CNC cutting the tuner head veneer
lazar engraving the tuner head veneer.
Screwing on the template for the head
Using the bandsaw to cut around the template
Using the router to trim the neck of my guitar
Using the router to trim the head of my guitar
Using a different router bit to flush trim the neck
Drilling holes in the head for the tuner pieces
Sanding the neck to look good
Using the router on the back of the neck
Hand filing the neck of the guitar neck
Putting the frets in the fret board
Sanding the underside of the neck to get rid of a hump
Using a orbital sander to sand my neck
using a special file to file the edge of my neck
My design in Carveco
My design in mastercam
My final design in master cam
My board with the design engraved in
The front supports laid out on the front
Sanding the body of my guitar
all the clamps on while gluing my back on
Flush trimming the edges of my guitar
Filing the edge of my guitar flush
Routing so I can put a piece of banding on my guitar body
Sanding the top of my guitar
Routing the sides of the guitar
Putting the banding on the back of my guitar
The top banding put on my guitar.
Sanding the back of my guitar
Guitar pre-finished and pre-pocketed.
Pre-finish continued.
Putting the neck pocket in my guitar body.
My neck with a handle on it so it can be sprayed.
My neck ready to be sprayed.
Looking for glue with lackerthinner
A coat on my guitar body
My neck with a coat on it.
Putting the strap buttons on my guitar.
getting my bridge area ready to be glued.
Screwing on my bridge
Rubbing the frets out
Rubbing out again
The guitar finished
My guitar stand design in autoCAD
My design in MasterCam
Sanding my guitar stand
The top of my guitar stand
Me putting finish on the guitar stand
The guitar stand drying with finish
Tink on my guitar stand
The class with there guitars
Home
About
RCHS
Orientation to Technology
Stem 1
Production 1
Production 2
3D Printing
CADD/CAM
CADD/CAM 2
CADD
Contact