SETH'S E-PORTFOLIO
Home
About
RCHS
Orientation to Technology
Stem 1
Production 1
Production 2
3D Printing
CADD/CAM
CADD/CAM 2
CADD
Contact
Filing off the extra tape.
Marking to drill the holes
drilling holes
Using a scootch bright pad to rough up the finish.
cutting off extra wood
using a table saw to cut a board
Putting glue on the shelf to finish it.
Cabinets about halfway done
Screwing in the top of another shelving unit.
screwing into to add supports for the cabinets.
Screwing in supports for the other cabinet set
The cabinets setup and installed in one of our teachers classroom.
Using a router to trim material.
drilling a small hole for a screw in material
using a band saw to cut a slot on the faceframe material.
Pocket holing faceframe material.
sanding the edge of the shelves
using a wide belt sander on the face frame material.
drilling in using pocket holes
using a table saw
using a jig while using a table saw
using a scotch bright pad on a face frame
more drilling
using a planer on a shelf
Counter screwing
putting glue in for a shelf
using the router on a shelf
using a drill press on a cabinet door
putting the hinges in on a cabinet door
my class standing in front of the cabinets we built for the shop
using the table saw on face frame material to cut a slot.
Spraying finish on a face frame
Home
About
RCHS
Orientation to Technology
Stem 1
Production 1
Production 2
3D Printing
CADD/CAM
CADD/CAM 2
CADD
Contact